Embedded Access Control Board
Descriptions:
1.Technical Parameters：
| Operating voltage | DC 12V±10% |
| Working current | <100mA |
| Dimensions | 90mm*36mm*16mm |
| Temperature | -20℃-60℃ |
| User capacity | 15000 Cards |
| Card reader type | EM Card (ID Card）/Anti-copy ID Card |
| Reading distance | 1-10cm |
2.Steps to set up the management card and restore factory settings：
Step 1: Disconnect the power supply, jump the jumper cap on the S1 pin to pins 2 and 3, and then power on again. After three long beeps, the green light flashes quickly (the menu password is now restored to 123456)
Step 2: Swipe two blank cards in succession (the first is "add card", the second is "delete card"), then the red light flashes slowly, and there are continuous short beeps, indicating that the management card is set successfully
Step 3: Disconnect the power supply again, jump the jumper cap on the S1 pin back to pins 1 and 2, and then power on again
Advantages:
Truly anti-copy ID card technology; rejects standard ID cards, cloned cards, and NFC-emulated cards for access.
Embedded design allows for direct integration into building intercom systems, unit entrance doors, and access control terminals.
Supports standard WG26/WG34 output, ensuring compatibility with the vast majority of host controllers.
Features long reading distance, rapid recognition, and exceptional stability.
Ideal for: Residential communities, unit entrance doors, upgrading legacy access control systems, and retrofitting building intercom systems.
